Ashlar masonry joints and Tooled finish - Stones.

Tuesday, February 8, 2011

Ashlar masonry joints.
Ashlar stones may be finished with smooth faces and bedded with thin joints, or the stones may have their exposed edges cut to form a channelled or ‘V’ joint to emphasise the shape of each stone and give the wall a heavier, more permanent appearance. The ashlar stones of the lower floor of large buildings are often finished with channelled or V joints and the wall above with plain ashlar masonry to give the base of the wall an appearance of strength. Ashlar masonry finished with channelled or V joints is said to be rusticated. A channelled joint (rebated joint) is formed by cutting a rebate on the top and one side edge of each stone, so that when the stones are laid, a channel rebate appears around each stone, as illustrated in Fig. lilA. The rebate is cut on the top edge of each stone so that when the stones are laid, rainwater which may run into the horizontal joint will not penetrate the mortar joint.

A V joint (chamfered joint) is formed by cutting all four edges of stones with a chamfer so that when they are laid a V groove appears on face, as illustrated in Fig. 11 lB. Often the edges of stones are cut with both V and channelled joints to give greater emphasis to each stone.


Fig. 111 (A) Channelled joint. (B) V joint.

Tooled finish 
Plain ashlar stones are usually finished with flat faces to form plain ashlar facing. The stones may also be finished with their exposed faces tooled to show the texture of the stone. Some of the tooled finishes
used with masonry are illustrated in Fig. 112. It is the harder stones  such as granite and hard sandstone that are more commonly finished with rock face, pitched face, reticulated or vermiculated faces. The softer, fine grained stones are usually finished as plain ashlar. 

Fig. 112 Tooled finishes.

Related Posts by Category:




3 comentarios:

Anonymous said...

Thanks for this article, I learned some tips that I can use when I'm already hired as a Stonemason in Geelong Vic. If you want to work in their company, you can visit their website here for more available jobs.

ElijahBennet said...

Normally I don't read article on blogs, but I would like to say that this write-up very forced me to try and do it! Your writing style has been surprised me. Thanks, quite nice article. Alexandr Shcolyar

Anonymous said...

Excellent explication.




-------------------------------------------------
I work in Stabilit America frp panels

Post a Comment

 
 
 

Labels